Fitting Michael 1 and 2 Items to New figures?
sjaammons
Posts: 185
https://www.daz3d.com/michael-s-conforming-halloween-heads So I bought this since it was 2 bucks and looked useful to my needs, but I've run into a problem: My Daz program doesn't have Michael 1 or 2 and trying to find these figures in the store proved impossible. They wouldn't show up. Like are they a discontinued figure?
Usually I've gotten around using really old wearables by fitting them to a Gen 1 figure since it's through them you can access fitting options for those old figures, but I can't find Michael 1 or 2 anywhere. Is there a workaround to getting really old wearables to fit to new figures (like Gen 8) or is the Michael 1 and 2 stuff so old that they're unusuable?
Daz 3D is part of 
Connect
DAZ Productions, Inc.
7533 S Center View Ct #4664
West Jordan, UT 84084
Licensing Agreement | Terms of Service | Privacy Policy | EULA
© 2025 Daz Productions Inc. All Rights Reserved.
Comments
You could probably try just hiding the head and some or all neck bones of your figure, then parent the head to the neck bone and adjust position/scale as needed to look right. I'm not sure that there is a Michael 1 clone for any Genesis, but even if there is the distortion caused by AutoFitting would quite possibly be worse than any fudging needed with parenting.