Loading...
> >

How do I? Genesis 3 OBJ for morphing

Sfariah DSfariah D Posts: 26,528
in Daz Studio Discussion

I want to create a Genesis 3 OBJ for importing into modeling software like Blender or Wings or ect.   Basically I want basic Genesis 3 female and male so I can make my own morphs and then be able to load the new morphs into Genesis 3 figure.

Comments

  • mjc1016mjc1016 Posts: 15,001

    Load just the base model, don't add any morphs.  Then go to the Parameters and turn the Resolution to Base.  That should turn off any subdivision.  Then export...

  • Sfariah DSfariah D Posts: 26,528
    mjc1016 said:

    Load just the base model, don't add any morphs.  Then go to the Parameters and turn the Resolution to Base.  That should turn off any subdivision.  Then export...

    Thanks.  I was forgetting the resolution part. Guess it is time for me to go to bed.

  • SickleYieldSickleYield Posts: 7,644
    edited November 2016
    Also turn off the mouth HD and navel morph that are on by default before exporting.
    Post edited by SickleYield on
  • Sfariah DSfariah D Posts: 26,528
    SickleYield said:
    Also turn off the mouth HD and navel morph that are on by default before exporting.

    Where are those morphs?  I am unable to find them as I need to go to bed ASAP

  • mjc1016mjc1016 Posts: 15,001

    If you select Currently Used in Parameters, they'll show up...

    The good thing is, once you export a set, you won't have to do it again.

  • Sfariah DSfariah D Posts: 26,528

    Are there any starter suits for Genesis 3?

Sign In or Register to comment.