Loading...
> >

Changeing The display mode of your mesh in Bryce 7

Cool BlueCool Blue Posts: 38
edited December 1969 in Bryce Discussion

Yes:

I'm new to Bryce. I just wanted to know if there was way to change the way an object is displayed. ? So I don't half to model in wire frame mode all the time ? An example of this would be making a cube primitive a solid object rather than a wire frame cube. ?


Please write back soon. I really appreciate all the support.


Thanks again
Michael

Comments

  • ChoholeChohole Posts: 33,604
    edited December 1969

    Little icon on the right hand set of icons, towards the bottom, changes your display mode. I think it's the little cube (from memory), can't check as I am 95% through a render.

  • HoroHoro Posts: 10,644
    edited December 1969

    I don't know whether I understand your problem. Have you hit the large green round render button yet?

    render.jpg
    221 x 489 - 18K
  • HoroHoro Posts: 10,644
    edited April 2013

    This is the control chohole refers to (red arrow). Click on it and it opens the menu shown left of it.

    wireframe.gif
    380 x 434 - 14K
    Post edited by Horo on
  • Cool BlueCool Blue Posts: 38
    edited December 1969

    Dear Mate:


    Thanks for all your support I. really appreciate it I had a feeling it was to simple fore me to figure out. LOL !! Have a great day, and I'm sure I'll be talking to you again. Your screen shots were very helpful.


    Thanks again bro
    Michael

Sign In or Register to comment.