Installing Hexagon through DIM
Kev914
Posts: 1,110
How do you install Hexagon and the beta and get them to go where you want them. I have a path listed under Applicaitons in DIM that points to where I want them to go...on my D drive. But when I install them, they keep going to my C drive and it creates new paths under the Application tab where it decided to put them. So I end up with 4 paths for Hexagon on the Application tab,.Or should the paths be listed under the installation tab? Right now the only paths on that tab have to do with DIM itself.
Daz 3D is part of 
Connect
DAZ Productions, Inc.
7533 S Center View Ct #4664
West Jordan, UT 84084
Licensing Agreement | Terms of Service | Privacy Policy | EULA
© 2024 Daz Productions Inc. All Rights Reserved.
Comments
Software installs to the 32-bit and 64-bit directories listed in your installation tab - and then updates the path in the application tab. So change the default 32 bit and 64 bit installation directories to point to your D drive - and make sure they are different directories. I use D:/bits-32 and D:/bits-64. Note that these will become your Studio install directories as well if you delete and reinstall studio.
I do the same, but use "D:\Program Files" for 64-bit and "D:\Program Files (x86)" for 32-bit. I'm lazy and that means I only have to change the letter at the beginning to redirect the installation paths. :)
Just thought I'd nudge in here with a little tip, when DAZ does an update for DAZ Studio or Hexagon you may have to change your preferences in each app for the Hex-DS bridge to work properly. I've done a screen grab of my preferences.
Like Jonny says, the locatons change if you are using 32 or 64 bit machnes.
Edit - Took me ages to load this picture properly - Getting old LOL