Loading...
> >

Exporting G2F as OBJ for zBrush

jaxprogjaxprog Posts: 312
edited December 1969 in New Users

Looking for fellow zBrush users to help me here.

I have included 3 screenies.

1) The export options when exporting to obj
2) The polycount of G2F as exported as obj
3) The comparison polycount of G2F when using GoZ

I noticed that the export options does not have zBrush... Like Really?
So I have done a number of exports using Daz Studio, Hexagon and unchecking all the options. No matter how many times I do it the polycount on the OBJ export is around 85K.
Using GoZ the polycount is around 21K

I was wondering...
1) why the huge difference
2) Is there way to export an obj to the lower 21K like using GoZ and how

Gen_GoZ.JPG
168 x 276 - 13K
Gen_OBJ.JPG
169 x 270 - 13K
Daz_OBJ_Export.JPG
505 x 583 - 55K

Comments

  • SickleYieldSickleYield Posts: 7,639
    edited December 1969

    Select G2F.

    Go to the Parameters Tab and Mesh Resolution.

    Set it to Base and subdivision to 0.

    Now it will export at the proper face count.

  • jaxprogjaxprog Posts: 312
    edited December 1969

    Thank you Sickleyield!!
    I am going to put your merbabes on my wishlist. I always buy from my wishlist first and foremost.

    I have already purchased the breast fixer product when it came out, but because you took the time to help me. I will bless you back and buy from you.

  • SickleYieldSickleYield Posts: 7,639
    edited December 1969

    jaxprog said:
    Thank you Sickleyield!!
    I am going to put your merbabes on my wishlist. I always buy from my wishlist first and foremost.

    I have already purchased the breast fixer product when it came out, but because you took the time to help me. I will bless you back and buy from you.

    Aw, thanks! I hope your project goes well.

Sign In or Register to comment.