Loading...
> >

DS 4.6 Auto-fit - unsupported figure - SOLVED

hjakehjake Posts: 933
edited December 2013 in Daz Studio Discussion

When I try to auto-fit some V4 tight fit pants to Gen 5 base figure I get the auto-fit dialog, but none of the figure templates I have show up in the drop down list where it says unsupported.

1. I have the latest DS 4.6 installed.

2. My Gen 5 content is in a single folder (including Gen 5 Starter Essentials).

3. My Gen 6 content is in a single folder (including Gen 6 Starter Essentials).

4. My Base content is in a single folder.

Therefore 3 folders.

5. I have SRMS and Gen X and every Gen 3 and 4 to Gen 5 compatibility item.

6. I re-imported content db just in case DS didn't know what I have installed.


Can someone please help me fix this?

2013-12-20_172212.jpg
390 x 588 - 73K
Post edited by hjake on

Comments

  • JimmyC_2009JimmyC_2009 Posts: 8,891
    edited December 1969

    It sounds as though your CMS is not running, have you checked that?

    In Windows, go to the Task manager and look for ContentManagementServer.exe as a running process. If it is not there, try starting it form Start > All Programs > DAZ 3D.

    If CMS is not running, you wont have any Smart Content or Categories and Products either.

  • JaderailJaderail Posts: 0
    edited December 1969

    If all three folders are read by DAZ Studio properly the Autofit should run properly. As noted check to see if the CMS has failed.

  • hjakehjake Posts: 933
    edited December 1969

    Well you are correct. CMS is being stopped and restarting the service does not fix it. I have to restart DS 4.6.

    CMS keeps running up until the point I try to fit the V4 pants to base genesis.

    I moved all genesis 5 & 6 content into 1 folder along with DS base content and updated the content library folders. That did not help.

    Any suggestions how I can fix this?

  • JaderailJaderail Posts: 0
    edited December 1969

    Did you Reset the DataBase? It will now hunt content in orphaned folders until the Database gets told not to.

    Do these one at a time in this order. TOP check first. Bottom check second and then Middle check. Let each run fully then close DS and reopen DS. I think that will fix your issues.

    Capture-001.png
    289 x 265 - 43K
  • hjakehjake Posts: 933
    edited December 1969

    Thanks to both of you for responding.

    Yes it was the CMS. I had fiddled with my library folders so much, it did not have a clue how to handle the changes.

    Your suggestions would have worked if my DS and CMS installations were not so messed up.

    I did try your steps but I could tell it was too fubar'd to fix that way.

    So I wiped Carrara, DS, and CMS from my system and registry and then did a vlean install.
    Now it works.

    Again thanks for the help :-)

    I am happy again ...... atleast until the next problem :-)

Sign In or Register to comment.