Loading...
> >

So how does one export G8M in Cr2 format?

2»

Comments

  • TugpsxTugpsx Posts: 753

    I know this is a seriously old thread but was wondering if anyone got Genesis 8 characters to work with Mimic Pro. to do this you will need to export a compatible CR2. I have had limited success so I was checking to see if others got it to work.

     

  • Richard HaseltineRichard Haseltine Posts: 102,464

    Export the base resolution figure, with no addons, as OBJ to /Runtime/Geometries/Some folder/, then use the CR2 Exporter. However, do bear in mind that, as far as I am aware, Mimic will not read weights from the CR2 so the rigging may well be very wrong.

  • TugpsxTugpsx Posts: 753

    Richard Haseltine said:

    Export the base resolution figure, with no addons, as OBJ to /Runtime/Geometries/Some folder/, then use the CR2 Exporter. However, do bear in mind that, as far as I am aware, Mimic will not read weights from the CR2 so the rigging may well be very wrong.

    Should I covert to TriAx before exporting. There was some info about that being successful.

  • WendyLuvsCatzWendyLuvsCatz Posts: 38,535

    it might look ugly in Mimic pro missing geometry but if you use the DAZ provided dmc file it does export a useable pz2 animated pose that works in DAZ studio 

    I use it occasionally with a couple of scary cr2 figure I saved and it works perfectly on new duf loads in DAZ

  • TugpsxTugpsx Posts: 753
    edited December 2021

    Will have to redo the CR2 export again but at least the character shows. Im using the file exported with studios builtin export.

    mimicCapture.PNG
    610 x 367 - 38K
    Post edited by Tugpsx on
Sign In or Register to comment.