Loading...
> >

How to fresh re install G2F?

BobvanBobvan Posts: 2,652
edited October 2019 in Technical Help (nuts n bolts)

Through errors and duplications as mentioned on several occasions my G2F takes over 10m minutes to load and is impossible to merge onto large scenes. What is the best way to purge and re install manually? Is there a trouble shooting clean up option or files to remove and re install? I manually install by unzipping files into My Library...

Post edited by Bobvan on

Comments

  • Richard HaseltineRichard Haseltine Posts: 102,484

    It isn't the base you wold need to reinstall but the additional morphs that need pruning - ideally by uninstalling, though you can just edit the /data/daz 3d/genesis 2/ female/morphs folder (from memory, and assuming you use DIM or manual unzipping to install).

  • jestmartjestmart Posts: 4,449

    Don't install manually use DIM, just be sure to run it first in off-line mode so that you can set your preferences.

  • BobvanBobvan Posts: 2,652
    edited October 2019

    It was installed manualy. How do I know which morphs cause the issue log file?

    Post edited by Bobvan on
  • Richard HaseltineRichard Haseltine Posts: 102,484

    It may be two morphs, but the log file will list the second (I think). Soemtimes not, sometimes it will be an error in a single file, but that should be rare as it would be caught in testing.

  • BobvanBobvan Posts: 2,652

    Found and removed the evil little buggers now loads in 45 seconds vs 12 minutes..

Sign In or Register to comment.