Loading...
> >

DAZ 4.12 and ManFridays Renderque

plaul2002plaul2002 Posts: 127
in Technical Help (nuts n bolts)

I am currently having issues with Renderque after updating to Daz 4.12 and was wondering if anyone else was having similar issues. Basically if I render one image "normally" in Daz, no issues. When I run Renderque with same images and X number of additional scenes it will run the render for about a minute and then shut it down with grainy grey or black final render and move on the next doing the same over and over. I've rebooted, checked my settings etc. I'm exasperated. Any thoughts?  Running WIndows 10

Comments

  • kenshaw011267kenshaw011267 Posts: 3,805

    I use renderqueue every day. I've had no issues in 4.12

  • plaul2002plaul2002 Posts: 127
    edited December 2019

    It appears to only occur if I have the Windows Preview Lights on.  If I toggle that off and render individully it renders fine. 

    And it's only these set images if I run the que on ones I've done previously I no issues. 

    Strange.

    Post edited by plaul2002 on
  • plaul2002plaul2002 Posts: 127

    So it might not be ManFriday's.  I open the seen hit render and it renders for 1 min spits out a grey black scene at the end of the min.  I close that render and hit render again and it renders just fine.  What the hell is going on with this scene?

Sign In or Register to comment.