Animate2 just isn't simple!
george_7648d0cf
Posts: 14
I have a gen8 male walking from the background to the foreground. I am using the forward [1 cycle] stretched so the "walk" takes about 10 seconds. I stopped the loop, but at the end of the timeline, I want the figure to stay in the foreground, NOT return to the starting point in the background. I've been trying for the past hour to get what I want - stop and stay in the foreground. Nothing I have tried works.
Can someone bail me out? I would be most appreciative!
Daz 3D is part of 
Connect
DAZ Productions, Inc.
7533 S Center View Ct #4664
West Jordan, UT 84084
Licensing Agreement | Terms of Service | Privacy Policy | EULA
© 2024 Daz Productions Inc. All Rights Reserved.
Comments
Consider the animate2 actions like sections. It shows you what it does. You can arrange a group of sections together and then at some point instead of using the Animate2 panel, go to the Timeline panel. Each section is not going to loop there. The entire Timeline will play out.
Be careful not to move the camera around, use one of the viewing options to check different angles.
Additional poses and tweaks to poses can be done on the Timeline as well.