Goggles Issue
narutobleachonepiece0
Posts: 42
So I guys I made myself a pair of Goggles for Genesis 8 Male, they look nice and clean all. I parent them on Gen8. All works fine. Until I change character, they become a total mess, I experienced this before when I made a pair of Glasses for Genesis 8 Female, I tried them on different character, and they become a total disaster. Images uploaded below. Any solution idea for this ?
ApplicationFrameHost_RSAKP91D5W.png
747 x 388 - 476K
ApplicationFrameHost_SZ8Csc3veF.png
662 x 411 - 434K
Daz 3D is part of 
Connect
DAZ Productions, Inc.
7533 S Center View Ct #4664
West Jordan, UT 84084
Licensing Agreement | Terms of Service | Privacy Policy | EULA
© 2025 Daz Productions Inc. All Rights Reserved.
Comments
A parented item will not pick up morphs, a fitted figure will.
Isn't that the same, it is fitted, using transfer utility. I checked the weight painting but it doesn't do much.
If it's fitted to the figure, rather than just parented, then any morph that is set to AutoFollow should project into it - mesh resolution permitting.