Canceling a Filament or OpenGL Render

MRU Studios

Canceling a Filament or OpenGL Render

Hello everyone!

I'm relatively new to DAZ Studio.  I've been using it extensively for an ongoing project over the last 4 months.

I've been lurking these forums an they're great!  I've found a ton of very useful and helpful information.  :).

What I'm trying to figure out is if there is a way to Cancel a Filament or OpenGL render once started.  Unlike IRay rendering there is no dialog box available to cancel the render.  I just have to let it run to completion.  I tried Ctrl + Q while DAZ Studio had focus.  This brings up the save changes dialog box.  I was able to cancel the render 1 time doing this by clicking Cancel on that dialog box, but every time I've tried after that the dialog box was unresponsive and just paused rendering until I pressed X to close.

Sometimes I make a mistake I don't realize until after I've started the render and then it's to late.  I have to wait or kill DAZ Studio using Task Manager.

I'm sorry if this is not the right place to post this question.  I couldn't find an answer to this anywhere on the forums.

Thank you for any help you're able to provide.  :)