Loading...
> >

Gen X2 and Gen 4 figures.

JoltrastJoltrast Posts: 199
edited June 2021 in The Commons

I haven't used GenX2 for a few years now but I'm pretty sure I was able to transfer Gen 4 morphs to Genesis (as well as G2/3).

However when I look at my source tab, all I can see are Genesis figures (No Poser Gen4). Have I forgotten to do something in the setup?


Images attached are from the product page.
Thanks in advance!

GenX2.png
923 x 649 - 224K
source1.png
500 x 287 - 95K
Post edited by Joltrast on

Comments

  • LindseyLindsey Posts: 2,001

    It's been a while since I used GenX2, but you click on the Load Figure button and load a poser Gen4 .cr2 figure.  Once you load a Poser .cr2 figure, it will then show up in the figure list when you click on the Source button.

  • HavosHavos Posts: 5,400

    Have you installed V4, M4 etc? Also you should install them in the same place as you put Genesis Essentials.

  • JoltrastJoltrast Posts: 199

    Lindsey said:

    It's been a while since I used GenX2, but you click on the Load Figure button and load a poser Gen4 .cr2 figure.  Once you load a Poser .cr2 figure, it will then show up in the figure list when you click on the Source button.

    Perfect, that's what worked. I was a bit confused as the Source Button was pre-populated with all the Genesis figures, but no Legacy/Poser figures!

  • LindseyLindsey Posts: 2,001

    Glad to hear!

Sign In or Register to comment.