Loading...
> >

DAZ 4.7 Victoria 4 Morphs and Shapes Parameters? Where are they gone?

jarmu77jarmu77 Posts: 0
edited December 1969 in Daz Studio Discussion

Hello there.

I've not used DAZ for quite a while and I was reinstalling it recently with the newest version.

So after I've installed it I fired DAZ Studio up and loaded my V4.2 figure. Then I applied the usual Elite, Muscles and Morphs++ and wanted to start shaping the character.

That's where I'm stuck tho, as all the morph and shaping otpions do not show up in the parameters-tab. The only thing showing is "Male Body" and "Male Body NoScale".
Even under "General" or "All" the sliders to adjust the shapes are nowhere to be found.

So where have they gone?

Comments

  • JimmyC_2009JimmyC_2009 Posts: 8,891
    edited December 1969

    Then I applied the usual Elite, Muscles and Morphs++ and wanted to start shaping the character.


    I use the PowerLoader for Morphs++, but how did you load them?

    I can see Morphs++ in Parameters > General > Morphs|Shapes. There has been no change at all in the way these work in 4.7 to the best of my knowledge.
  • fixmypcmikefixmypcmike Posts: 19,600
    edited December 1969

    Where are V4 and the morph packs installed?
    Is that location listed in Content Directory Manager in DS as a Poser-format content folder?

Sign In or Register to comment.