Loading...
> >

Using mirror/symmetry to level eyes

N-RArtsN-RArts Posts: 1,522
in The Commons

I've got quite a few morphs where I've got to reset the appearance of the eyes. I'm using Geometry Editor ---> Morph Editing ---> Clear Selected Deltas from Favourites.

The only problem that I'm having is getting the irises level. Is there a way I can get Daz to mirror the position of the left eye, to the position of the right eye (or viceversa)?

Thanks.

 

 

 

Comments

  • IceCrMnIceCrMn Posts: 2,142

    There's the Symmetry Tool

    Select one of the eyes then press CTRL+Y to bring up the UI.

    Not sure if this will do what you are looking for though.

    SymmetryTool.jpg
    311 x 377 - 34K
  • N-RArtsN-RArts Posts: 1,522
    edited April 2022

    IceCrMn said:

    There's the Symmetry Tool

    Select one of the eyes then press CTRL+Y to bring up the UI.

    Not sure if this will do what you are looking for though.

    That's it! I can never remember what the keys are.

    My first set of eyes have been fixed!

    Thank you for replying smileyyes

    Post edited by N-RArts on
  • richardandtracyrichardandtracy Posts: 5,889

    Must admit I don't use the keyboard shortcut (use lots of bits of software & end up using the wrong one), I use menu option 'Edit| Figure| Symmetry' which gets to the same place.

    Regards,

    Richard.

     

  • N-RArtsN-RArts Posts: 1,522

    richardandtracy said:

    Must admit I don't use the keyboard shortcut (use lots of bits of software & end up using the wrong one), I use menu option 'Edit| Figure| Symmetry' which gets to the same place.

    Regards,

    Richard.

     

    I was trying to look for it in the menu. I just couldn't see it. As my Mum would say, "if it was/were a dog, it would've bit me".

    Thank you for replying :)

     

Sign In or Register to comment.