Loading...
> >

Fitting a centaur garment onto a human figure - need some help!

arks0ngarks0ng Posts: 273
in The Commons

Hello! I'm trying to fit Willow Outfit for Genesis 8 Female Centaur onto a human figure to use over the top of some pants etc., and while the front dForces very nicely, since it was made for someone a bit more equine in the hindquaters, the back sticks out no matter how I mess with the dForce settings.

I don't suppose anyone knows of a solution to make it hang down better? :D

(I'm trying to attach photos to demonstrate this, but uploading photos doesn't seem to be working. But essentially it's the same as can be seen in this image 

If worst comes to worst, I'll just use geomtery editor to remove the back flaps entirely

Comments

  • Catherine3678abCatherine3678ab Posts: 8,342

    Just an idea ... possibly with a morph [you might have to make unless garment comes with one] applied at say 30 on the timeline, use the timeline for the simulation.

  • Matt_CastleMatt_Castle Posts: 2,572

    While I would personally argue that you're trying to go in the wrong direction...



    ... have you checked that it hasn't got a dForce weightmap?

Sign In or Register to comment.