updated - Just a tip about using dynamic hair and geografted head parts
ibr_remote aka infinity10
Posts: 469
UPDATE: this fails to work as well
So I used the commercial goegrafts to enable G9 to use G8 UVs. I applied the G9 dynamic hair (Hime hair in this case) and if it is Fitted To the figure, only the fringe hairs exist (of course, because the rest of the scalp is taken up by the geograft). Therefore, I parent the hair to the head instead of Fitting it to the figure.
Post edited by ibr_remote aka infinity10 on
Daz 3D is part of 
Connect
DAZ Productions, Inc.
7533 S Center View Ct #4664
West Jordan, UT 84084
Licensing Agreement | Terms of Service | Privacy Policy | EULA
© 2024 Daz Productions Inc. All Rights Reserved.
Comments
Yes, because the strand-based hair could not find Head as the root for line generation... A workaround is that you select Legacy Graft before loading the hair...