Loading...
> >

dForce Beachcomber Hair simulation

jhogenboom_da69c035a9jhogenboom_da69c035a9 Posts: 111
in Technical Help (nuts n bolts)

It just took about two hours for this hair to simulate. Is there a way to speed that up? Thanks for your help.

Comments

  • crosswindcrosswind Posts: 8,059

    It just took 20 seconds to finish a simulation with 'Start Bones From Memorized Pose' on a G8 figure in sitting pose on my side. You may first try a simulation on a bare G8 base figure to see if there's any problem. If there no problem, go back to your scene:

    1) Select 2 sub-nodes (Top & Bottome) under the root node of Beachcomber Hair Cap G8M, turn off Preview PR Hairs

    2) Select all other wearables on the figure, filter 'Smoothing', turn them off. Then simulate....

  • jhogenboom_da69c035a9jhogenboom_da69c035a9 Posts: 111

    AHA! I bet I left preview on. Thanks. I'll try this.

  • crosswindcrosswind Posts: 8,059

    jhogenboom_da69c035a9 said:

    AHA! I bet I left preview on. Thanks. I'll try this.

    Oh, did you ? Hoho ~~ don't do that before sim. enlightened

Sign In or Register to comment.