Loading...
> >

emissive.

csteell_c2893e4ab6csteell_c2893e4ab6 Posts: 476
in Daz Studio Discussion

is it difficult to make a material or skin emissive on a G9 Figure? I know I can purchase some itmes but I would like to make my own! Cheers

Comments

  • Richard HaseltineRichard Haseltine Posts: 100,758

    If it uses the Iray Uber Base shader just set the Emissive Colour to non-black, optionally with a map to limit the effect, in the Editor tab of the Surfaces pane and then adjust the light properties below that.

  • csteell_c2893e4ab6csteell_c2893e4ab6 Posts: 476

    Richard thank you for your reply. Can you expand on this? Do you mean I do not use a G9 Base Skin for emissive purposes? Is there a UBER skin for G9 Figures? Cheers

  • Richard HaseltineRichard Haseltine Posts: 100,758

    The PBR Skin sahder, used by a lot of recent characters, does not have emission. You could use a Geometry Shell, with regular Iray Uber, to layer emissive areas on top of the base skin.

  • crosswindcrosswind Posts: 6,915
    edited December 2023

    Or check this https://www.daz3d.com/pbr-skin-plus, if you prefer to PBRSkin...It's PBRSkin plus with emission enablement 

    Post edited by crosswind on
Sign In or Register to comment.