Loading...
> >

Anyone one else having issues with the new Road Trip Hippy Van?

2»

Comments

  • TaozTaoz Posts: 9,979
    edited September 2017

    Have another version I bought a few years ago in another store, never used it so decided to check it out and compare. It showed up to be just an obj, plain mesh with no textures except a few with logos for the roof and spare tire, no rigging, and no interior at all. Cost $12. Here they are together, I've used mec4d's shaders for the old one.

     

     

     

    vw_both_01.jpg
    1780 x 1070 - 910K
    Post edited by Taoz on
  • BoorsmanBoorsman Posts: 265

    Does anybody know what the backseats are suppoesed to be sitting on?  When I turn the bedding off, and turn on the backseats, the rear backseats are on the raised part of the van, while the front backseats are hovering in the air.  M I missing something?

     

  • kyoto kidkyoto kid Posts: 41,260
    edited September 2020
    Mattymanx said:
    th3Digit said:

    in regards to pivots

     but DAZ studio one needs to make it a figure and fiddle with those tiny red and green hip bone arrows is a right pain.

    Why doesn't DAZ studio have an easy way to set pivots on props?

     

    Use the Joint Editor Tool and the Tool Tab to change pivot points.  Its the exact same tool PAs use when rigging the models.

    ...I had to do that with the luggage hold doors on the Greyhound Scenicruiser Bus from Rendo as well as they would pivot at the centre not the top. A small inconvenience considering the only other models of it I've seen are on the pro sites and like patwojtko mentions, cost 100s..

    Post edited by kyoto kid on
  • WendyLuvsCatzWendyLuvsCatz Posts: 38,614
    edited September 2020

    this thread was necroraised from tne dead

    I apparently bought it since too but not even used it yet surprise

    (and caught flack from a user for criticism when I hadn't even bought it yet cheeky was asking about the rigging)

    Post edited by WendyLuvsCatz on
Sign In or Register to comment.